flamethrower

How to prevent and fix stringing of 3D printed parts #3dPrintingForBeginners

Leave a Comment / 3d printing, Coronavirus, flamethrower / By admin

If you have 3d Printed anything before, you have probably run into stringing. Stringing is where strands of filament are pulled across your 3D printed object, leaving a less than desirable finish. In this video I show you how to fix 3d print stringing when 3d printing Bolivair Coronavirus masks that blend both PETG and …

How to prevent and fix stringing of 3D printed parts #3dPrintingForBeginners Read More »

DIY: Boring Company Not A Flamethrower build

Leave a Comment / 3d printing, boring company, flamethrower, how to, Tesla / By admin

I searched high and low to find someone to loan me a Boring Company Not a Flamethrower without luck. I then scoured eBay only to find that the flamethrowers are being auctioned off for upwards of $1000, so I decided to try to build one myself. I found pieces of information scattered all over the …

DIY: Boring Company Not A Flamethrower build Read More »